It is always best to isolate the barrel so the check ring is the only thing being tested, and outside influences are minimized. Question: With a 2-shot machine, how do I perform a check ring capability study on my 2nd shot? My Response: You want to run the shot by itself if possible. Using both […]
Author Archives
Routsis Training
Flash, with Lower Part Weight…
Just because the mold is flashing, does not mean the part weight has increased… Question: Hello, we have a part which is flashing, but the part weight is lower than before. Does this make sense? Answer: When this is the case, it is usually caused by too much material entering the mold during injection. As the […]
Screw Retraction During Packing or Recovery…
Many older electric molding machines (and a few new ones) have a programming glitch which causes the screw to retract if the packing or back pressure is set too low. Question: When trying to make a short shot, I set my packing pressure to 0 and the machine pulls the screw back during packing. How can […]
Optimize Your Clamp Movements
Part removal is the easiest part of the injection molding process to optimize and there is no excuse for basic clamp movement optimization. Situation: While walking the recent NPE 2015 trade show in Orlando, many of the processes were dialed in beautifully where the mold quickly opens and closes while the part is ejected on […]
Train Anywhere on Any Device
Hello Readers, This post is to inform all our readers that all our online content is now deliverable on any device with a high-speed internet connection. You can learn more about our training options at: http://www.traininteractive.com/training/ -Andy